Towing a Utility Trailer in 6 Easy Steps(2)

3.Then you need a pigtail wire connector which fits properly with the tow vehicle.On the one hand,the wire ends of the tow vehicle should be attached to the hitch,on the other hand,the receiver of the utility trailer need to be attached to the wire ends of the trailer. All above would and must guarantee the normal operation of all lights contains brake lights, taillights and signals once the accessories are connected.

4.Next use the trailer hitch inbuilt jack or a hydraulic jack to lift the trailer receiver whose position ought to be two to four inches higher above the trailer hitch ball.At the same time,put the blocks down the trailer to ensure it remains stopping. Confirming that all of them are parallel to the trailer vertically. 

5.Turn off the trailer and the tow vehicle and check again for sure they won't move,then match the trailer receiver which can drop onto the trailer hitch ball after this action with the tow vehicles hitch together.Afterwords,click down the receiver ball,insert the locking safety pin into place.

6.You should know the exact size of chains to make a correct buy,attach each one chain to the each one side of a receiver by the chain hook through the keyhole works on the chain hook's end,while others ought to be connected to eyehole of the safety chain. This precaution ensure the trailer hitch is attached to the ball firmly and keep the chains safe by lock pins.  

Make it certain that all towing accessories are into right place and safe,which can maximum reduction of losses.All useful tools should be ready and examined for sure in advance.