9 Easy Steps to Install a Gooseneck Trailer Ball(2)

5.Insert the crossbar bolts through the hitch head holes,both of them should be fit properly.At the time you put the hitch into place,your assistant should place the hitch head in position.To use an adjustable wrench,slide the suitable washer into each bolts threaded end and a proper nut tightened into each bolt.

6.Insert the trailer hitch ball's bolt into the vehicle bed to ensure it lie completely centered in the hole.If not,the spacer placed on it should be adjusted until reach the standards.

7.Drill holes as the requirements of the installation instructions,in which the holes should be drilled on pre-marked indicators and through the hitch head's bottom into the truck's bed. Be more careful since the holes cannot be drilled twice.

8.Insert correct bolts into holes and springs,then tighten proper nuts on each bolts' threaded end to secure the bolts to the hitch head and complete the trailer ball.Guarantee connections be tighten firmly.

These easy steps help you finish the installation a lot,during the process,the manual is of great importance.